Spearhead RHD 230, Handbook & Parts Manual

Page: 3 / 32

RHD Series RHD
230/250/280
3
IMPORTANT
VERIFICATION OF WARRANTY REGISTRATION
DEALER WARRANTY INFORMATION & REGISTRATION
VERIFICATION
It is imperative that the selling dealer registers this machine with Spearhead Machinery
Limited before delivery to the end user
– failure to do so may affect the validity of the machine
warranty.
To register machines go to the Spearhead Machinery Limited web site at
www.spearheadmachinery.com
, log onto ‘
Dealer Inside
’ and select the ‘
Machine
Registration button
’
which can be found in the Service Section of the site. Confirm to the
customer that the machine has been registered in the section below.
Should you experience any problems registering a machine in this manner please contact the
Spearhead Service Department on 01789 491867.
Registration Verification
NOTE TO CUSTOMER / OWNER
Please ensure that the above section has been completed and signed by the selling dealer to
verify that your machine has been registered with Spearhead Machinery Limited.
IMPORTANT: During the initial ‘bedding in’ period of a new machine it is the
customer’s responsibility to regularly inspect all nuts, bolts and hose connections for
tightness and re-tighten if required. New hydraulic connections occasionally weep
small amounts of oil as the seals and joints settle in
– where this occurs it can be
cured by re-tightening the connection
– refer to torque settings chart below. The tasks
stated above should be performed on an hourly basis during the first day of work and
at least daily thereafter as part of the machines general maintenance procedure.
CAUTION: DO NOT OVER TORQUE HYDRAULIC FITTINGS AND HOSES.
TORQUE SETTINGS FOR HYDRAULIC FITTINGS
HYDRAULIC HOSE ENDS PORT ADAPTORS WITH BONDED SEALS
BSP Setting Metric BSP Setting Metric
1/4”
18 Nm 19 mm
1/4”
34 Nm 19 mm
3/8”
31 Nm 22 mm
3/8”
47 Nm 22 mm
1/2”
49 Nm 27 mm
1/2”
102 Nm 27 mm
5
/8”
60 Nm 30 mm
5/8”
122 Nm 30 mm
3/4”
80 Nm 32 mm
3/4”
149 Nm 32 mm
1”
125 Nm 41 mm
1”
203 Nm 41 mm
1.1/4”
190 Nm 50 mm
1.1/4”
305 Nm 50 mm
1.1/2”
250 Nm 55 mm
1.1/2”
305 Nm 55 mm
2”
420 Nm 70 mm
2”
400 Nm 70 mm
Dealer Name:
……………………..…………………………………………………………….
Dealer Address:
…….………………………………………………………………………….
Customer Name:
……………………..…………………………………………………………
Date of Warranty Registration:
……/……/...……
Dealer Signature:
………………..……