RHD Series RHD
230/250/280
24
Troubleshooting
PROBLEM
POSSIBLE CAUSES
REMEDIES
Irregular Cut
Worn, bent or broken flails
Replace flails
RPM too low
Increase RPM
Machine not level to the ground
Correct mounting on tractor
Clogged material caused by
excessive forward speed
Reduce forward speed
Noise
Loose bolts
Check and tighten bolts
Damaged components
Repair or replace
Noisy gearbox
Lack of lubrication
Top up oil to correct level
Worn gears
Replace worn components
Worn bearings
Replace worn components
Vibration
Broken, worn or missing flails
Replace flails
Rotor out of balance
Balance or replace rotor
Worn rotor bearings
Replace rotor bearings
Excessive backlash in joints
Worn pins
Replace pins
Tight bearings
Bearings dirty or ungreased
Clean and grease
Violent
lowering
down
of
machine
Lower machine gently
Belts overheating
Belts slipping on pulleys
Tension belts
Flails contacting the ground
Raise cutting height
Working speed too high
Reduce working speed
Machine Disposal
Disposal of this machine and any of its component parts must be performed in
a responsible and inoffensive manner respecting all current laws relating to
this subject. Materials forming this machine that must undergo differentiated
division and disposal are:
– Steel
– Mineral Oil
– Rubber
– Plastic
