RHD Series RHD
230/250/280
16
PTO Shaft Measurement
Measure the PTO shaft and cut to the
dimension shown
– the finished length of the
PTO shaft should be 75mm (3”) less than the
measured distance ‘
A
’ - between tractor
shaft and gearbox stub shaft - to enable
fitting.
NOTE:
For subsequent use with different tractors
measure again, there must be a minimum
shaft overlap of 150mm (6”).
Fit PTO in position and attach the torque
chains to a convenient location to prevent the
shaft guards from rotating.
PTO Shaft Length Adjustment
1. Shorten outer plastic tube to 40mm
less than the shortest envisaged shaft
length.
2. Remove the marked tube.
3. Remove same length from inner
plastic tube and metal shaft profiles
(inner and outer).
4. De-
burr all edges and remove ‘swarf’ to ensure smooth operation.
Pre-Operational Checks
Before commencing work with the machine the following checks should be
performed:
•
Make a visual inspection of the machine to ensure it is in good operational
condition.
•
Check all safety guarding is in position and in full working order.
•
Check rotor for missing or damaged flails and replace if required.
•
Check all greasing points are well lubricated.
•
Check gearbox oil level.
•
Check belt tension and adjust if required.
•
Check PTO speed and direction match that of the machine.
