8999127: v1 14/08/2018
Page 1.7 of 1.10 pages
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
1
Machine Description
1.1
Intended Usage
1.1.1
Allowed Uses
The Quadsaw is used for cutting branches and trees up to a max. diameter of 100 mm without the branches being
torn by being mounted on hydraulic hedge cutters. The machine is supplied with a special bracket enabling
mounting on various vehicles/machines.
Branches with a diameter over 40 mm, must be cut one of the time.
Vertical cutting is allowed up to a 45 degree angle. Horizontal cutting is possible on hedges with a width up to 80
cm. and a branch diameter up to 20 mm. Thicker branches might stop the blades and get stuck in the machine.
When the Quadsaw works it guarantees the required level of safety even in the presence of an insignificant
malfunction of its components or hazardous operating conditions, however, always within the permitted uses.
The Quadsaw must not be used for purposes other than those described in this manual.
1.1.2
Improper Uses
Blades must be mounted to cut in a downward, vertical direction only, in the same direction as the tractor.
1.1.2.1
The Quadsaw is usable up until
a maximum angle of 45°
and must not be used at any greater angle than
this to ensure that debris doesn’t hit the tractor. It should
never cut horizontally
.
The machine must not be used if there are any broken or missing saw blades.
1.1.2.2
Never use the Quadsaw on an unstable or non-suitable vehicle.
1.1.2.3
The Quadsaw is specifically designed for Spearhead’s various reach arm machines and HXF frames.
1.1.2.4
The Quadsaw must not be used for purposes other than those described in this manual.
DANGER!
Spearhead declines any and all liability for damages caused by the Quadsaw to persons, animals or
property, resulting from use other than that described in this manual, or due to damage caused by
negligence or by not observing the instructions contained in this manual.
Figure 1.1 Spearhead Quadsaw LRS 1402
