MODE 3.1 Installation Instructions
Page 6
012
3
4
5
678
9A
B
C
D
EF
IR
IR
+12
+12
GND
GND
485 A
485B
+ RELAY
- RELAY
ADDRESS
MODE 3.1
Riverside, CA www.speakercraft.com
MADE IN CHINA
1
2
3
1
4
5
4
6
6
MODE 3.1 FEATURES
REAR PANEL
1. KEYPAD LOCKING TABS -
Fit into the upper Mounting
Bracket Tab Slots to secure the keypad to the bracket.
2. SPEAKER RELAY MUTE TERMINAL -
Connects to a
SpeakerCraft EPR-1.0 Relay Muting Module for individual
room mute when using multi-channel amplifi ers for sub-
zone expansion.
3. KEYPAD PUNCH-DOWN BLOCK -
110 style punch-
down terminal connects to the Zone Keypad Terminals on
a SpeakerCraft MZC-66 or a KCM-1.0 when using MZC-88.
4. KEYPAD ANGLE TAB -
Fits into the channeled lower
Mounting Bracket Tab Slots to allow fl ush installation (fl at
to wall surface) or with the lower portion of the keypad
sloping away from the wall at about a 15° angle. The
angle mount creates a special cosmetic appeal and pro-
vides an improved LCD viewing angle.
Figure 2
MODE 3.1 Rear Panel Features
5. ADDRESS SWITCH -
A unique hex address must be set for each MODE Keypad when connected on a common bus
within a single zone. Unique addresses are not required zone-to-zone (One keypad per zone). The switch provides up to
16 addresses (0 to F).
6. FACEPLATE RELEASE TABS -
Carefully push these recessed tabs to remove the MODE faceplate to change keycaps. It is
typically only necessary to press the tabs on the bottom of the keypad and then carefully pull the bottom of the faceplate
away from the MODE body.