MODE 3.1 Installation Instructions
Page 15
Keypad Angle
There are two options for mounting the MODE 3.1. One is a fl ush installation with the keypad fl at to the wall surface, and
the other is with the lower portion of the keypad sloping away from the wall at about a 15° angle. The angle mount creates
a special cosmetic appeal and provides an improved LCD viewing angle.
Flush Mount
To install the MODE 3.1 Keypad flush (flat) to the wall surface:
1. Slide the lower part of the keypad into the mounting bracket and position the
Keypad Angle Tabs
into the
rear chan-
nel
of the
Keypad Angle Tab Slots
.
2. Carefully press the upper corners of the keypad with both thumbs until the
Keypad Locking Tabs
snap into place.
Angle Mount
To install the MODE 3.1 Keypad with lower portion angled away from the wall surface at approximately 15º:
1. Slide the lower part of the keypad into the mounting bracket and position the
Keypad Angle Tabs
into the
forward
channel
of the
Keypad Angle Tab Slots
.
2. Carefully press the upper corners of the keypad with both thumbs until the
Keypad Locking Tabs
slide into place. (The
keypad will ‘lift’ slightly in the bracket when positioning the Locking Tabs.
NOTE:
In an angle mount, the keypad is not secure until the bezel has been installed. The bezel will hold the Locking Tabs in
place and secure the keypad to the bracket. Prior to installing the bezel in an angle mount, be careful if operating the keypad
and avoid incidental contact to prevent the keypad from falling out of the bracket and possibly damaging the keypad, the
wires or the wall.
BEZEL
Installation
With the keypad in place, carefully align the
Bezel Tabs
with the
Bezel Tab Clips
on the
Mounting Bracket
. Apply even
pressure around the bezel to slide it into place. The bezel is made of a plyable material that will ‘form fit’ to the wall surface
for a clean finish.
Removal
Take care when removing the bezel to not scratch custom wall surfaces or tear wall paper. Use a very small, thin tool or fin-
gernails, to carefully pull the sides of the bezel away from the wall surface.