MODE 3.1 Installation Instructions
Page 26
Whole House/Mute
6. Left click the
Whole House/Mute Tab
to confirm
Whole House and Mute Key Functionality. These func-
tions should have already been configured in the existing
project. Under
Whole House/Party Mode
, “
This Zone
Initiates”
should be checked to enable Party Mode from
a press and hold of the
Click Button
when selecting a
source on the MODE 3.1. “
This Zone Ignores...”
should
be checked to lock out Party Mode commands from other
zones. Under
Mute Key Functionality
, “
Internal Pre-
amp Muting”
should be checked to use the MZC zone
preamp muting function.
“EZ-Pad Relay Speaker Mut-
ing”
should be checked when using EPR-1.0 EZ-Pad Relay
Muting Module for muting individual rooms in sub-zone
expansion applications (multiple rooms in a single zone).
When Zone Whole House/Mute functions are set, left click
Apply
. (Refer to
Figure 21
)
Keypad Address
7. Any keypad whether an EZ-Pad or MODE 3.1 must have
its Address configured in EZ-Tools. If there is only one key-
pad per zone, all keypads can be set to the same Address.
Any time there is more than one keypad in a zone, each
of the keypads within that zone must be set to a different
Address. Right click the EZ-Pad or MODE 3.1 icon in a par-
ticular zone. Left click the
EZ-Pad
or
MODE 3.1 Setup
pop-up. Left click the desired box to set keypad Address.
For the example, ‘0’. Left click
Apply
. The Keypad Address
will appear next to the Keypad Icon in Zone Setup. (Refer
to
Figure 22
)
Default AV Routing Commands
8. To assure that the sources connected to the MZC will be
properly routed to the local zone, a set of default A/V
routing commands can be assigned to the source icons
on the MODE 3.1. Under
Project Content/Zone Setup
,
right click the Zone 2 icon. Highlight and left click
Place
Default A/V Routing Commands
. The MZC Internal
Commands for all source A/V signal routing will be auto-
matically assigned to all sources available to the MODE in
Zone 2. (Refer to
Figure 23
)
8. This completes Zone Setup for integrating the MODE 3.1
into Zone 2. Left click the MODE 3.1 icon under
Project
Content/Zone Setup/Zone 2
. The
virtual MODE 3.1
will appear along with the
Button Properties Window
and the
Virtual Button Window
. (Refer to
Figure 24
)
Figure 21
Zone Setup Whole House/Mute Tab
Figure 22
Zone Setup Keypad Address
Figure 23
Place Default A/V Commands