MODE 3.1 Installation Instructions
Page 19
MODE 3.1 Connections
1. Strip approximately 1” to 1.5” from the outer jacket of the cable being connected to the MODE 3.1. DO NOT strip the
individual conductors.
2. Using a proper
punch-down tool
, connect each of the wires to the matching color terminals on the MODE 3.1
punch-
down block
. When making connections to the MODE 3.1 punch-down block ALWAYS pull the wire toward the middle
of the 3.1. Pulling the wires toward the outside will create diffi culty when installing the keypad into the Mounting
Bracket and will probably cause wires to become disconnected.
3. Prior to installing the keypad, attach the included
Wire Retainer
to the back of the MODE 3.1 as shown in
Figure 15
.
Remove the adhesive backing from the wire retainer and attach with the wire tie oriented vertically as shown, with the
retainer lock at the bottom. Pull the retainer over the wire and down through the lock as shown. This will help prevent
the wires from becoming disconnected during installation.
3. Terminate and connect the head-end connection as appropriate. If connecting
directly
to an MZC or KCM-1.0, Refer to
Figure 13
. If terminating in
RJ45
Connectors
and using
RJA-1.1s
Refer to
Figure 14
. Confi rm all connections prior to
powering up the system.
012
3
4
5
678
9A
B
C
D
EF
IR
IR
+12
+12
GND
GND
485 A
485B
+ RELAY
- RELAY
ADDRESS
MODE 3.1
Riverside, CA www.speakercraft.com
MADE IN CHINA
IR
IR
+12
+12
GND
GND
485 A
485B
Figure 15
MODE Wire Retainer