Spartherm Arte 1Vh, Installation Instructions Manual

Page: 11 / 28

GB 11
5.8. CONNECTION PIECE
The neck tube for the connecting piece is on the flue dome of the fireplace
insert. Connect to the chimney directly if possible. The fireplace insert can
be connected either vertically or horizontally. Use an enclosed wall lining
to make the connection to the chimney or follow the instructions of the
chimney manufacturer. Make the connecting piece out of molded firebrick
for house chimneys or sheet iron pipes made of steel plate that is at least
2 mm thick as per DIN 623, DIN 1298, DIN EN 1856 and the corresponding
molded parts.
Flue gas pipes inside the facing of the open fireplace have to be sheathed
with class A1 stone wool mats that are at least 3 cm thick, dimensionally
stable and non-combustible as per DIN 4102 part 1 and contain less than
1.2 % binder. The application limit temperature is at least 750 °C when
tested as per DIN 52271. The thickness has to be 6 cm instead of 3 cm if
the flue gas manifold is made of metal.
This does not apply if the connection piece is intended to be used for con-
vective heating of the ambient air.
COMMENT
Requirements of the connecting piece as per DIN 18160 part 2.
5.9. HEAT DISSIPATION
Since it is possible to use different fireplace unit construction types with
our fireplace inserts, it is essential to consult a professional company when
planning a fireplace unit. Make sure that the level of heat dissipation is
sufficient. Implement this by using convection air ducts in the facing or heat
dissipating facing elements.
eine formbest‰ndige D‰mmplatte von mind. 2cm St‰rke angebracht
Der Abstand zwischen Innenkante Heizgassammler und Simsbalken
muss mind. 16,5cm betragen.
werden.
3
Es muss ein bel¸fteter Abstand von 1cm oder unterhalb des Balkens
Der Balken muss auflerhalb des Strahlungsbereiches liegen. 1
2
1
2
3
5.5. SPECIAL MEASURE FOR FIRE PREVENTION
FOR HARDWOOD MANTELS
1 The beam has to be located outside of the radiation area.
2 The ventilated distance must be 1 cm or a dimensionally stable insulation sheet with a
thickness of approx. 2 cm has to be attached below the beam.
3 The gap between the inner edge of the combustion gas manifold and the mantel has to be
at least 16.5 cm.
GB