12
2.3.2 ASSEMBLY OF THE FACEPLATE ON THE
ROTARY BASE
ambiente a1/a2/a3/a4
The faceplate is located on top of the appliance upon delivery. The faceplate
should not be fitted until the stove has reached its installation location and has
been levelled. Be sure to unscrew the legs by a distance of 6-14 mm (Fig. 5a).
Next, undo the two fastening screws on the rear of the faceplate (Fig. 5b)
point B.
Now fit the faceplate around the rotary base. The faceplate has to be pulled
apart at the join to do this. After placing the faceplate in position, re-insert the
two screws at the join (Fig. 5b). Then screw the faceplate on to the retainers
provided (Fig. 5c).
Functioning of the rotary base is described under „3.3 Functioning of the
rotary base“ on page 32.
Fig. 5a
Fig. 5c
Fig. 5b
A
Faceplate
B
Undo screws
Chapter 2
2.3.3 ASSEMBLY OF THE HEAT STORAGE MASS
ambiente a3/a3 RLU/a4/a4 RLU
Storage stones can only be fitted or retrofitted to the ambiente a3 and a4
models.
If the ambiente a3 or a4 is ordered with storage stones, the front stone
and supporting plate are already fitted at the factory. For weight reasons,
the other storage stones are assembled on site. Stoves are supplied with
a rear flue gas connection as standard, unless otherwise specified at the
time of ordering.
To install the storage stones, start by removing the cover. Note that
the stove should not yet be connected to the chimney when doing this.
