– 9 –
Split Inverter Air-to-Water Heat Pump
Preparations Before Installation
Receiving Inspection
Upon receipt of the goods, the user shall inspect the unit carefully to confirm that no damage has occurred during the transport, that
the screws are not loose, and that all spare parts have been received. If there is damage, please contact the manufacturer.
Handling and Hoisting
For the outdoor unit (as shown in Figure 3.1), the weight is concentrated on the label side. When handling and arranging the slings,
special attention should be paid to balance the unit’s center of gravity to prevent falling over. Also note that outdoor unit should always
remain in the upright position. Failure to comply will void warranty.
Do not touch the fins with bare hands, which may cut your fingers.
For ease of handling, the purchaser should use a fork lift truck or a cable crane. When using a cable crane, make sure the cable has
sufficient load-bearing capacity which must be more than 3 times the weight of the unit. The cable should completely wind around the
pallet, and a guard plate should be added to the surface of the unit body where the wire touches. During handling, the unit should be
kept horizontal to avoid damage due to reckless operation.
If the product is accompanied by a packaging tie, do not use the tie to lift or carry the product. The tie can easily break and cause
accidents or danger.
The weight of the indoor unit (as shown in Fig. 3.2) is concentrated on the top of the body and fixed on the wooden board by means
of a fixed beam. When handling, pay special attention to the direction to prevent falling over.
Before the unit is officially installed, remove the packaging, cut the packaging tape, and remove the bottom wood pallet. If using a
cable, pass the cable to the designated location.
Dispose the plastic packaging bags properly and do not allow children to play.
25
Installation Instructions
Acceptance
Inspection
Preparations before Installation
Upon receipt of the goods, the user shall inspect the unit carefully to confirm that no damage
has occurred during the transport, that the screws are not loose, and that all spare parts have
been received. If there is damage, please reject the goods.
For the outdoor unit (as shown in Figure 1), the weight is concentrated on the label side. When
handling and arranging the slings, special attention should be paid to balance of the unit’s center of
gravity to prevent falling over.
Do not touch the fins with bare hands, which may cut your fingers.
For ease of handling, the purchaser should use a fork lift truck or a cable crane. When using a cable
crane, make sure the cable has sufficient load-bearing capacity which must be more than 3 times the
weight of the unit. The cable should completely wind around the pallet, and a guard plate should be
added to the surface of the unit body where the wire touches. During handling, the unit should be
kept horizontal to avoid damage due to reckless operation.
If the product is accompanied by a packaging tie, do not use the tie to lift or carry the product. The
tie can easily break and cause accidents or danger.
The weight of the indoor unit (as shown in Fig. 2) is concentrated on the top of the body and fixed
on the wooden board by means of a fixed beam. When handling, pay special attention to the
direction to prevent falling over.
300mm
Within 200mm
Protection pad
Wire rope
Center of gravity to the
compressor side
Mounting feet
Figure 1
Fixed by hanging beam
开关
Fixed by M8 screws
Figure 2
Before the unit is officially installed, remove the packaging, cut the packaging tape, and remove
the bottom wood pallet. If using a cable, pass the cable to the designated location.
Dispose the plastic packaging bags properly and do not allow children to play.
Handling
&
hoisting
12"
8"
Protection pad
Secure to wall stud
Wire rope
Center of gravity to the
compressor side
Mounting feet
Secure with proper screws
into wall stud or appropriate
anchors
Figure 3.1 Outdoor Unit
Figure 3.2 Indoor Unit