Installation (Cont.)
Note:
a. When the battery gets low, there will be a low-
battery beep every 7 seconds from the handset.
b. If the battery becomes low while you are on a
call, you will be disconnected after about 1 minute.
Terminate the call quickly and put the handset in
the charge cradle to recharge the battery.
c. The battery will hold its charge for
several days out of the cradle, depending on use.
d. The handset must be fully charged before
attempting to access remote answering machine
features from the handset.
To Replace Batteries:
E. Connect the AC adapter into the back
of the unit and plug the other end to the
110/120 volt outlet.
F. Raise antenna on base for best reception.
Handset Battery Charging
The battery pack in the handset must be fully
charged for about 10-14 hours before using the
telephone. The Answering Machine may be used
prior to the handset being fully charged. An
extension telephone will be required until the
handset is charged.
Installation (Cont.)
Note:
To maximize your battery`s life, we
recommend that you periodically fully drain
the battery and then recharge it. To do this,
unplug your phone line cord from your wall
phone jack. Press the TALK key.
Return the handset to the charger and allow to fully
charge for 12 hours. If this process is completely
monthly, it will reduce the memory build up that
occurs from frequent partial charging.
1.Two cases you can enter contrast setting. From system setup mode. Press ``FLASH`` button in standby.
2.For handset LCD. Press ``#`` or ``*`` button to set the desired contrast. Press ``MEM`` button to
confirm. After confirmation, display returns to standby.
3.For base LCD. Press Volume ``UP`` or ``DOWN`` button to set desired contrast.
Press ``FLASH`` button to confirm. After confirmation, display returns to standby.
15
16
After connecting the unit to AC power, leave the
handset in the charger cradle for ten to fourteen
hours before using it. Later, it will take less time for
the battery to recharge. The CHARGE LED on the
charger will be lit when the handset is in the cradle.
2. Remove old battery.
3. Install new battery.
4. Close battery cover.
Charge 10-14
hours before first
use.
Handset Registration
Display Contrast Setup
The unit shall be pre-programmed by one default ID code at ex-factory. However, user can also review the
ID code with the following procedures.
Press the ``CONF`` button on base for 8 seconds to enter the registration mode. Base LCD shall display
``WAIT FOR REG`` with blinking and the base shall wait for 1 munite to check if the cordless handset will
start registration.
Within this 1 munite, press the CONF button on handset for 8 seconds to activate the registration.
Handset LCD shall display ``REGISTER NOW`` with blinking and the handset shall be able to complete the
registration successfully with the base within 5 seconds.
If registration is successful, both LCD will show ``REGISTER OK`` for 10 seconds together with a
confirmation tone. New ID code will be used and saved in non-volatile memory.
If registration failed, both LCD will show ``REG FAILED`` for 10 seconds together with an error tone. Old
code will be retained.
1. Remove battery
cover.
CONF
SPEAKER
TUV
JKL
OPER
ABC
PAGE/INTCM
*
CONF
0
PQRS
7
8
2
1
GHI
4
5
REDIAL/PAUSE
#
WXYZ
9
FLASH
3
MNO
6
DEF
POWER
IN USE
PDF created with FinePrint pdfFactory trial version
http://www.fineprint.com