southpaw enterprises, inc.
®
Instruction Sheet
In-FUN-ity
Wall Ladder - Brick / Block Wall 152000
Store these instructions along with the enclosed maintenance checklist
in a safe place. You may also access them on our website.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file
this Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone
who is using Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.
If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
MATERIALS LIST:
1 - Ladder Top Section (6 rungs)
1 - Hardware Kit Containing:
1 - Ladder Bottom Section (4 rungs)
4 - 1/4-20 Anchors
6 - 3/8-16 x 1-1/2” Button Head Cap Screws
8 - 1/4” Fender Washers
6 - 3/8” Flat Washers
4 - 1/4” Internal Tooth Lock Washers
1 - 7/32” Hex Key
4 - 1/4-20 x 1-3/4” Hex Head Cap Screws
1 - Instruction Sheet
1 - Maintenance Checklist
The In-FUN-ity Climbing System is a modular system. Each instruction sheet is designed to assist you in assembling
the particular item that it accompanies. Since these items may be configured in various manners to best suit your appli-
cation, the instructions do not suggest any particular order of assembly. If you have any questions about how to set up
your system, please contact Southpaw customer service for help.
Working Load: 250 lbs.
ASSEMBLY:
•
Place the top and bottom sections of the
ladder on the floor with the wall attach-
ment boards on the floor. Position the
top and bottom so that the three holes in
the bottom of the top section will be
aligned with the three t-nuts in the top of
the bottom section.
•
Slide the top section into the bottom sec-
tion as shown in picture at right. Be sure
that the head of the screw holding the
ladder rung slides into groove in the bot-
tom section. Align the bolt holes with
the t-nuts.
•
Place a 3/8” flat washer on each of the 3/8 x 1-1/2” bolts. Start the bolts from the inside, through the holes in the top
section and screw it into the t-nut in the bottom section. Start all six bolts then tighten securely with the hex key
wrench provided.
ATTACHING TO WALL:
•
Position the assembled Therapy Ladder Wall against the wall where you wish to install it. Make sure that there are
no obstructions such as electric outlets interfering with installation.
•
Make a mark on the wall in the center of each of the four outside slots. This will determine where to drill for the an-
chors. Remove the ladder from the wall.
TOP
BOTTOM
T-NUTS
GROOVE FOR SCREW HEAD
TM
Summary of Contents for In-FUN-ity Climbing System
Page 2: ...1 2 3 4 5 6...
Page 3: ...7 8 9 10 11...
