southpaw enterprises, inc.
®
Instruction Sheet
In-FUN-ity
Hook-On Ladder 152017
Store these instructions along with the enclosed maintenance checklist
in a safe place. You may also access them on our website.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file
this Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone
who is using Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.
If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
MATERIALS LIST:
1 - Vertical Ladder (2 pieces)
6 - Wood Screws #8 x 1”
6 - Button Head Cap Screws 3/8-16 x 1-1/2”
6 - Tapcon Screws 1/4” x 1-1/4”
2 - Button Head Cap Screws 3/8-16 x 1-1/4”
1 - 7/32” Hex Key Wrench
6 - 3/8” Flat Washers
1 - Instruction Sheet
2 - Angle Brackets
1 - Maintenance Checklist
2 - Acorn Nuts 3/8-16
WORKING LOAD:
200 lbs.
ASSEMBLY:
•
Position the top and bottom sections of the ladder on the floor. Position the top and bot-
tom so that the three bolt holes in the bottom of the top section will be aligned with the
three t-nuts in the top of the bottom section. Slide the top section into the bottom sec-
tion as shown in Fig. 1. Be sure that the head of the screw holding the ladder rung
slides into groove in the bottom section. Align the bolt holes with the t-nuts. Place a
3/8” flat washer on each of the six of the 3/8 x 1-1/2” bolts. Start the bolts from the in-
side, through the holes in the top section and screw it into the t-nuts in the bottom sec-
tion. Start all six bolts then tighten securely with the hex key wrench provided.
•
The pre-assembled top of the ladder (Fig. 2) will hook onto the side of the expansion kit.
•
Angle brackets are provided to anchor the bottom of the ladder to the floor (Fig. 3).
MAINTENANCE CHECKLIST:
All of the following wear points should be checked on a monthly basis and recorded on the
checklist
enclosed.
•
Check that all screws and bolts are tight. If any screws or bolts are found to be loose, discontinue use until they
are tightened.
•
Check wood surfaces for cracks and splinters. If cracks are found, discontinue use immediately and contact
Southpaw Enterprises. Splinters may be sanded smooth and refinished with clear lacquer.
MATTING PRECAUTIONS:
•
Always use appropriate matting under and around equipment.
STORAGE PROCEDURE:
•
Make sure that equipment is not accessible by clients without proper supervision.
CLEANING INSTRUCTIONS:
•
Check with your infectious disease department before using these procedures.
•
Check for client allergies first.
•
Clean with a damp cloth using soap and water or disinfectant.
•
Dry before using.
Fig. 1
Fig. 2
TM
Fig. 3
Summary of Contents for In-FUN-ity Climbing System
Page 2: ...1 2 3 4 5 6...
Page 3: ...7 8 9 10 11...
