southpaw enterprises In-FUN-ity Climbing System, Instruction Sheet

Page: 14 / 23

southpaw enterprises, inc.
®
Instruction Sheet
In-Fun-ity Expansion Kit 152013
Store these instructions along with the enclosed maintenance checklist
in a safe place. You may also access them on our website.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file
this Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone
who is using Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.
If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
MATERIALS LIST:
1 - Vertical Ladder (2 pieces) 6 - Tapcon Screws 1/4” x 1-1/4”
1 - Horizontal Section 2 - Button Head Cap Screws 3/8-16 x 1-1/4”
14 - Button Head Cap Screws 3/8-16 x 1-1/2 2 - Acorn Nuts 3/8-16
16 - 3/8” Flat Washers 1 - 7/32” Hex Key Wrench
2 - Angle Brackets 1 - Instruction Sheet
6 - Wood Screws #8 x 1” 1 - Maintenance Checklist
WORKING LOAD: 300 LBS
The In-FUN-ity Climbing System is a modular system. Each instruction sheet is designed to
assist you in assembling the particular item that it accompanies. Since these items may be con-
figured in various manners to best suit your application, the instructions do not suggest any par-
ticular order of assembly. If you have any questions about how to set up your system, please
contact Southpaw customer service for help.
ASSEMBLY:
•
Position the top and bottom sections of the ladder on the floor. Position the top and bot-
tom so that the three bolt holes in the bottom of the top section will be aligned with the
three t-nuts in the top of the bottom section. Slide the top section into the bottom section
as shown in Fig. 1. Be sure that the head of the screw holding the ladder rung slides into
groove in the bottom section. Align the bolt holes with the t-nuts. Place a 3/8” flat washer
on six of the 3/8 x 1-1/2” bolts. Start the bolts from the inside, through the holes in the top
section and screw it into the t-nuts in the bottom section. Start all six bolts then tighten
securely with the hex key wrench provided.
NOTE:
IF YOU HAVE PURCHASED A JUNGLE-GYM EXTENDER, REFER TO THAT
INSTRUCTION SHEET AT THIS TIME, AND ATTACH THE EXTENTIONS BEFORE MOVING
ON.
•
Position the top of the assembled ladder inside one end of the horizontal section and align
the screw inserts (Figs. 2 & 2 A). Put a 3/8” flat washer on each of four of the 3/8” x 1-1/2”
cap screws. Start a screw through each of the holes and into each screw insert. Tighten
all four screws securely using the hex key wrench provided.
•
Raise the assembled ladder and horizontal section and position the available end of the
horizontal section against the wall ladder with the sides of the horizontal section on the
outside of the wall ladder (Fig. 3). Align the holes in the outside boards with the screw
inserts. Put a 3/8” flat washer on four of the 3/8” x 1-1/2” cap screws and put them
through the holes in the board and start them into the screw inserts. Tighten all four
screws securely using the hex key wrench provided.
TM
Figure 3
Figure 1
Figure 2
Figure 2-A
Your hardware will
be packed with the
Horizontal section