southpaw enterprises, inc.
®
Instruction Sheet
In-Fun-ity Jungle Gym Extender 152014
Store these instructions along with the enclosed maintenance checklist
in a safe place. You may also access them on our website.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file this
Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone who is
using Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.
If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
MATERIALS LIST:
1 - Horizontal Section
1 - Connector w/ Bar (Not Assembled)
2 - 1/4” x 2” Dowel Screws
1 - 7/32” Hex Key Wrench
16 - 3/8” Flat Washers
1 - 4.0 mm Hex Key Wrench
16 - 3/8-16 x 1-1/2” Button Head Cap Screws
1 - Instruction Sheet
1 - Maintenance Checklist
NOTE: This item is intended for use if you already have the Southpaw In-FUN-ity Wall
Ladder with the Expansion Kit # 152013. We recommend that you use a maximum of two
Extenders with the Expansion Kit for a total of twelve feet.
The In-FUN-ity Climbing System is a modular system. Each instruction sheet is designed
to assist you in assembling the particular item that it accompanies. Since these items may
be configured in various manners to best suit your application, the instructions do not sug-
gest any particular order of assembly. If you have any questions about how to set up your
system, please contact Southpaw customer service for help.
ASSEMBLY:
1. You will have one “loose” wood dowel, and two “loose” pieces of wood. These pieces
constitute the part labeled “Connector with Bar”. The wood pieces have a recess on
one side that fits the wood dowel. Push the wood dowel into this recess and screw the
1/4” x 2” wood screw into the pre-drilled hole in the end of the dowel Using the smaller
of the hex key wrenches (4.0 mm). Repeat on the other end, making sure the two ends
line up.
2. Put a flat washer onto each of the 16 button-head cap screws.
3.
If your Expansion Kit is not already assembled to your Wall Ladder
, line up the
Jungle-Gym Extender with the identical part from the Expansion Kit. Fit the connector
piece in-between the two, lining up all 16 holes. From the inside of the connector piece,
put a button head cap screw w/ washer into each hole and tighten. Then continue with
your Expansion Kit instructions.
4.
If your Expansion Kit is already assembled to your Wall Ladder
, remove the verti-
cal ladder from the end of your Expansion Kit (Fig. 1). Lay aside the four screws and
washers as they will be used to re-attach the ladder to the extender.
5. Position the connector piece with the wood dowel inside the sides of the Expansion Kit
boards in place where the vertical ladder was attached. Align the holes of the connec-
tor with the screw inserts. Put a 3/8” x 1-1/2” cap screw w/ washer through the hole in
the connector and start it into the screw insert. Do not tighten at this time. Start a bolt
into each of the four holes on each side of the connector (Fig. 2). After all eight bolts
are started, tighten each one securely using the hex key wrench provided.
TM
Figure 2
Figure 4
Figure 1
Figure 3
WORKING LOAD:
250 lbs.
Summary of Contents for In-FUN-ity Climbing System
Page 2: ...1 2 3 4 5 6...
Page 3: ...7 8 9 10 11...
