Galaxy G2
- 67 -
§6.3 Hardware operation
This section will focus on how to make the configuration on the radio through the buttons on the
control panel.
6.3.1 Channel (CH)
Press
to move the cursor to CH, then press
to enter this
parameter setting mode, press
again to select the channel, and press
to confirm the settings and exit.
6.3.2 Frequency
Press
to move the cursor to the frequency, then press
to enter
this parameter setting mode, press
to move the cursor, and press
to
change the frequency, and press
to confirm the settings and exit.
Note: There are 2 frequency ranges of this radio, 410MHz~450MHz and 450MHz~470MHz. And
the frequency of each channel should be set in the same frequency range, changing the frequency
beyond the range is not allowed. For example, if channel 1 is with the frequency 411.125, and it
belongs to the range of 410MHz~450MHz, then the other channels frequency should be in the
same range too.
6.3.3 Power mode (L W)
Press
to move the cursor to power setting, then press
to enter
this parameter setting mode, press
again to select the power level
(L=low, H=high), and press
to confirm the settings and exit.
6.3.4 Air (Air baudrate)
Press
to move the cursor to air baudrate setting, then press
to
enter this parameter setting mode, press
again to select the
baudrate(9.6K=9600…), and press
to confirm the settings and exit.
