South Bend Tools
For Machines Mfd. Since 10/20
Model SB1093
-19-
P R E P A R A T I O N
10.
Lay table/fence assembly on belt sander and
align slots with second and third holes in
mounting spacer plate, leaving bottom hole
exposed and secure with (2) M10-1.5 x 25 cap
screws and (2) 10mm fender washers (see
Figure 22
).
Note:
Make sure the gap between the table
and sanding belt is no more than
1
⁄
16
". Loosen
table lock knobs and adjust as necessary (see
Figure 23
).
Figure 23. Belt sander table/fence gap.
1
⁄
16
" Gap Between
Table and Sanding Belt
Figure 22. Mounting table/fence assembly.
12.
Carefully peel protective backing half way
from back of sanding disc.
13.
Slide half of sanding disc (that still has
backing) down behind front plate and line
top of sanding disc with top of aluminum
disc.
9.
Place back stop across belt sander and align
with two bottom holes, then attach using
(2) M6-1 x 20 hex bolts and (2) 6mm lock
washers as shown in
Figure 21
.
Figure 21. Belt Sander back stop.
Belt Sander Back Stop
11.
Loosen (2) hex bolts on front cover of disc
sander (see
Figure 24
).
Note:
Loosening hex bolts will allow easier
access to install sanding disc. DO NOT
remove bolts.
Figure 24. Disc sander cover.
Front Cover Hex Bolts
7.
Remove wood block, then tip machine to
other side, place block under machine,
and repeat
Step 6
to install remaining (2)
leveling feet.
8.
Place machine in desired location and level
using feet adjustment nuts.
Bottom Hole
Left Exposed
14.
Gently press disc adhesive to disc.
15.
Rotate disc 180°, then pull remainder of
protective backing off disc.
x2
x2
