South Bend Tools
For Machines Mfd. Since 10/20
Model SB1093
-29-
O P E R A T I O N
Disc Sanding
1.
DISCONNECT MACHINE FROM POWER!
2.
Adjust angles of work table and miter gauge
for operation.
3.
Connect sander to power, turn it ON, and
allow it to reach full speed.
4.
Place workpiece on the work table and firmly
against the miter gauge.
5.
With light pressure, slowly move workpiece
into the left side of the sanding disc. See
Figures 45–48
for examples of disc sanding.
The sanding disc can be used to create flat,
smooth ends and edges of workpieces.
To reduce the risk of your fingers getting
trapped between the work table and sanding
disc, make sure the table is approximately
1
⁄
16
"
away from the sanding disc.
Always keep the workpiece on the left side of
the wheel that rotates down toward the work
table. This will keep the workpiece from flying
out of your hands due to kickback.
Figure 46. Example of miter sanding.
Figure 47. Example of angle sanding.
Note:
To prevent burning the workpiece and
overloading the sanding disc, move the workpiece
slowly back and forth from the left side of the
sanding disc to the center.
To use sanding disc:
Figure 45. Example of 90° disc sanding.
Figure 48. Example of sanding round workpiece.
