South Bend Tools
South Bend Tools
-26-
For Machines Mfd. Since 7/19
Model SB1065F–SB1071F
P R E P A R A T I O N
The following adjustments have been made
at the factory. However, because of the many
variables involved with shipping, we recommend
that you at least verify the following adjustments
to ensure the best possible results from the lathe.
Step-by-step instructions for these adjustments
can be found on the Pages referenced below.
Factory adjustments that should be verified:
• Align Tailstock (Page 28).
• Compound Rest/Cross Slide Backlash
(Page 50).
• Compound Rest/Cross Slide Gib (Page
51).
• Half Nut Clamping (Page 53).
• Leadscrew/Feed Rod End Play (Page
53).
• Foot Brake/Motor Brake (Page 54).
• V-belts (Page 55).
Recommended
Adjustments
31.
Test chip guard safety switch by moving
guard to open position and try to start lathe.
The lathe should not start.
32.
Test lower-headstock door safety switch by
opening door and trying to start lathe.
The lathe should not start.
33.
Use coolant pump switch to start pump, and
test coolant flow.
34.
If no problems are found, lathe is ready for
use.
Note
: For DRO operation, refer to Fagor
Manual.
Spindle Break-In
No break-in required. This machine has had its
spindle bearings broken in at the factory and is
ready for full use after machine setup and test
run.
Summary of Contents for Oil Country Series
Page 65: ...South Bend Tools...
Page 66: ......
