South Bend Tools
South Bend Tools
For Machines Mfd. Since 7/19
Model SB1065F–SB1071F
-23-
P R E P A R A T I O N
To test run machine:
IMPORTANT:
If any problems are found during
test run, disconnect lathe from power and refer
to Troubleshooting on Page 60 for correction
before proceeding any further.
1.
Make sure master power switch on rear of
machine is turned OFF (see Figure 20).
Master Power
Master Power
Switch
Switch
Figure 20. Location of master power switch.
Figure 20. Location of master power switch.
2.
Read and understand safety instructions at
beginning of manual, take all required safety
precautions, and make sure all previous
preparation steps discussed in this manual
have been followed and completed.
3.
Clear away all tools and objects used during
assembly, lubrication, and preparation.
4.
Make sure chucks and jaws, if installed, are
secure and all bolts are in place.
5.
Push EMERGENCY STOP button on control
panel (see Figure 21).
6.
Make sure headstock, gearbox, and apron
oil levels are at full mark indicated by sight
glasses.
7.
Turn coolant pump switch to OFF position,
and point coolant nozzle into chip pan.
Figure 21. Headstock control panel.
Figure 21. Headstock control panel.
Summary of Contents for Oil Country Series
Page 65: ...South Bend Tools...
Page 66: ......
