South Bend Tools
South Bend Tools
For Machines Mfd. Since 7/19
Model SB1065F–SB1071F
-21-
P R E P A R A T I O N
Assembly
With the exception of the handwheel handles, the
lathe is shipped fully assembled.
To install handwheel handles, thread large
handle into carriage handwheel and small
handle into cross slide handwheel.
Lubricating Lathe
GEARBOXES MUST
BE FILLED WITH OIL!
LATHE MAY NOT
HAVE OIL INCLUDED!
Refer to the Lubrication
Section in this Manual
for Recommended
Oil Type.
When the lathe is delivered from the factory,
please do not assume that the headstock,
gearbox, and apron oil reservoirs have proper
amount of oil in them. It is always good practice
to drain and refill the oil when receiving new
machinery. Damage caused to the bearings and
gears from running the lathe without oil in the
reservoirs is not covered under warranty.
Refer to the Lubrication section, beginning on
Page 42, for details on how to check, add oil, and
prime the headstock oil pump.
In addition to filling the reservoirs, lubricate
all other points on the machine at this time.
This can be accomplished by following the
maintenance schedule on Page 40.
Figure 18. Electrical cabinet.
Figure 18. Electrical cabinet.
Master Power Switch
Master Power Switch
Incoming Power
Incoming Power
Strain Relief
Strain Relief
1.
Make sure master power switch at power
supply box is locked-out in the OFF position,
and then open lathe electrical cabinet door.
2.
Refer to Figure 18 to identify master power
switch and hole at bottom right of electrical
cabinet for incoming power.
Power Connection
After you have reviewed the Power Supply
Requirements section for guidelines and
completed all previous setup instructions, the
machine is ready to be connected to the power
supply by a licenced electrician.
To connect power supply wires to machine:
Summary of Contents for Oil Country Series
Page 65: ...South Bend Tools...
Page 66: ......
