South Bend Tools
South Bend Tools
-58-
For Machines Mfd. Since 7/19
Model SB1065F–SB1071F
S E R V I C E
Removing/Installing
Gap Insert
The gap insert directly under the spindle (see
Figure 92) can be removed to create additional
space for turning large diameter parts.
IMPORTANT:
The gap insert was installed, then
ground flush with the bed at the factory to ensure
a precision fit and alignment. If the gap insert is
removed, it may be difficult to re-install with the
same degree of accuracy.
Figure 92. Gap insert location.
Figure 92. Gap insert location.
Gap Insert
Gap Insert
Tools Needed
Qty
Hex Wrenches 10, 14mm ............................... 1 Ea.
Wrench 19mm .......................................................1
Wood or Dead-Blow Hammer ...............................1
Safety Glasses .......................................................1
Light Machine Oil ................................. As Needed
2.
Remove both way-end cap screws.
3.
Tighten dowel-pin jack nut until pin is
pulled free from gap insert.
4.
Tap outside of gap insert with a dead blow
hammer to loosen it, then remove it.
Figure 93. Fasteners holding gap in place.
Figure 93. Fasteners holding gap in place.
Gap-Bed Cap
Gap-Bed Cap
Screw (1 of 4)
Screw (1 of 4)
Way-End Cap
Way-End Cap
Screw (1 of 2)
Screw (1 of 2)
Dowel Pin
Dowel Pin
Jack Nut
Jack Nut
1.
Remove (4) cap screws in gap bed, shown in
Figure 93.
Removing Gap Insert
Summary of Contents for Oil Country Series
Page 65: ...South Bend Tools...
Page 66: ......
