ST2883 Series Operation Manual Chapter 2 General specifications
2-1
Chapter 2 General specifications
2.1 Specifications
Specifications ST2883-5
ST2883-10
Output for impulse voltage 100V~5000V
10V steps
5%±15V
500V~10000V
200V steps
5%±25V
Inductance test range
>10
μ
H >20
μ
H
Impulse energy
Max 250milli-Joules
Max 500 milli-Joules
Contents in waveform
display area on LCD
800×480 dot-matrix LCD
250×600 dot-matrix
Setup parameters, standard wave and test wave, comparison
result, file information, etc.
Sample wave
Sampling rate: 200MSPS/5ns, 100MSPS/10ns, 50MSPS/20ns,
25MSPS/40ns, 12.5MSPS/80ns, 6.25MSPS/160ns,
3.12MSPS/320ns, 1.56MSPS/640ns
Resolution: 8bits
Sampling point: 6000bytes
Standard wave sample
Sequential cycle, single cycle, one sample (up to 32 times of
sample averaging)
Input impedance
5M
Ω
Test speed
6 times/sec
Averaging rate
Number of test impulse
1 to 32 averaging rate
programmable
Number of demagnetizing impulse
0 to 16 averaging rate
programmable
Measurement function
Voltage, time and frequency
Trigger mode
Internal, Manual (Foot), External and Bus
Comparison method
AreaSize Comparison
DiffZone Comparison
Corona Comparison
PhaseDiff Comparison
Area size measurement
accuracy
±1%
Area difference
measurement accuracy
±1%
Comparison output
PASS/FAIL display
Beeper alarm
Beep mode
ON (adjust for high and low tone), OFF
Memory
Built-in memory: 100 files
USB disk memory
Interface
HANDLER (START, STOP, PASS, NG, BUSY, EOC, etc.)
RS232C USB Device USB Host LAN
