ST2883 Series Operation Manual Chapter 4 Introduction to [DISP]
4-3
4.3.1.3
LOOP
The instrument starts to sample standard waveforms, change frequency, and cycle
sampling.
Select
Select the sample waveform at the current frequency as the standard waveform.
Select & Check
Compare the sample wave with the standard wave at the current frequency, if the
compare result is within the error range, choose the sample wave at the current
frequency as the standard wave and return to the main menu; if the compare result is
beyond the error range, an error information will prompt and the instrument will keep
in the wait state to Start a new sample.
Start
Start loop test.
Return to previous page.
4.3.1.4
Modify
Lighten the icon to enable the roller. Revolve the roller to choose or modify the wave
color, voltage and sample rate.
Revolve the roller to move the cursor to this zone and press the roller for one time.
Then rotate the roller to choose the wave color.
Revolve the roller to move the cursor to this zone. Then rotate the roller to change the
voltage by 10V. The voltage ranges from 100V to 5000V.
Revolve the roller to move the cursor to this zone. Then rotate the roller to select the
desired sample rate.
4.3.1.5
Return to the main menu.
【
N
】
Volt 1000V
Samp: 200MSa/s
