21
ENGLISH
SPIRE XL 440 User manual
9.4. Scene Menu
This sub-menu can be accessed both from the main menu and from the window where
all the sub-menus are listed as shown in the figure below.
SUPER CMY SPOT 3IN1
001
23CHB 01. 01
00:58:17
ADDRESS
WORKMODE
DISPLAY
SCENE
ADVANCED
STATUS
001
12.0
NOR
FULL
Address
Workmode
Display
Scene
Advanced
Status
Escape
DMX Ctrl
Auto Run
Sound Ctrl
Scene Mode
Auto
M/S Choose
Master
Light Switch
OFF
After selection, the display will show all the “Scene” sub-menu options as shown in the
figure below.
Address
Workmode
Display
Scene
Advanced
Status
Escape
Scene Select
01.Pan
1
Scene Time
0. 0s
02.Pan Fine
03.Tilt
04.Tilt Fine
05.PT Spd
06.Frost
000
000
000
000
000
000
As already explained in the “Workmode Menu”, the device can work with the “Scene
Mode” operating mode. For further details see “9.2. Workmode Menu” on page 16.
In each scenario it is possible to modify and set all the parameters listed below.
To select the parameters you can use the [UP] and [DOWN] buttons and then the [EN-
TER] button on the control panel to enter the edit window where, again using the [UP]
and [DOWN] buttons, you can change the value of the selected parameter. Once the
desired value has been set, pressing the [ENTER] button will confirm the change made.
If you press the [MENU] button, you will exit the editing environment without storing
the change.
The parameter to be modified can also be selected with the touch of a finger directly
on the screen. A window will appear on the display where you can make the change. By
touching the / graphic buttons it is possible to increase/decrease the parameter
value. To save the set value touch the
graphic button. You can also change the
value by touching the red square and dragging it to the right or left as shown in the
next figure.
