Service Record Mio Carbon (Design 2018)
9 of 28
2020-09-01
B5
C4
C3
C2
C1
B4
B3
B2
A5
A4
A3
A2
A5
A4
A3
A2
A1
A1
B1
(1)
3.2.1 Seat heigh and seat tilt
3.2 Assembly group seat
The seat height is (next to the centre of grav-
ity) a significant factor for the ideal length for
turning the driving wheel and causes a positive
division of the child’s strength when using the
wheelchair.
A general rule is: with a straight (and relaxed
shoulder area) stance of the child, the elbows
should reach the side guard. Be sure that when
setting the seat height to check that the child
does not need to lift its shoulders when moving
the wheelchair.
A slight or strong seat tilt allows a safe and
comfortable seat position with a good distri-
bution of the seat pressure and promotes the
straightening of the pelvis.
(1
) By alternating the seat angle the seat height
can be changed in 1,5 cm steps up to 4,5 cm
and gives the following seat heights in the front:
Distance top edge of the seat to
Distance top edge of the seat to
ground (without seat cushion!)
ground (without seat cushion!)
degree of
degree of
tilting
tilting
with18“ with 20“ with 22“ with 24“ bore
degree
A1
315
mm/
31,5 cm
340
mm/
34,0 cm
360
mm/
36,0 cm
385
mm/
38,5 cm
B1
without
A2
330
mm/
33,0 cm
355
mm/
35,5 cm
375
mm/
37,5 cm
400
mm/
40,0 cm
B2
without
C1
slight
B1
strong
A3
345
mm/
34,5 cm
370
mm/
37,0 cm
390
mm/
39,0 cm
415
mm/
41,5 cm
B3
without
C2
slight
B2
strong
A4
360
mm/
36,0 cm
385
mm/
38,5 cm
405
mm/
40,5 cm
430
mm/
43,0 cm
B4
without
C3
slight
B3
strong
A5 -
400
mm/
40,0 cm
420
mm/
42,0 cm
455
mm/
45,5 cm
B5
without
C4
slight
B4
strong
• Remove the screws of the seat support-
ing angle
• mount the seat plate in the desired po-
sition,
• replace the screws and tighten them.
When setting the seat height regard the dai-
ly situations (pushing the wheelchair under
a table at school or nursery school etc.). Ac-
cording to the set position of the foot notch,
it must be ensured that the casters can turn
freely 360°.
