Service Record Mio Carbon (Design 2018)
15 of 28
2020-09-01
3.4 Assembly group leg support
3.4.1 Standard leg support
If the leg support is set too high, it will lead to kinking in the pelvis. A too low set will
block the blood and lymph circulation.
Therefore, leave enough space between the back of the knee and the seat cushion (about one
hand width - without thumb). The thighs must rest evenly on the seat cushion.
The leg support can be rotated 360 ° on the Mio (Design 2018) in the holder mount
(1G)
like a
Ferris wheel. This "turning" changes the distance between the seat and footplate both horizon-
tally and vertically.
Vertical adjustment of leg support (lower leg
length):
• (1)
Remove screws
(A)
on both sides.
• Place base plate
(B)
in the desired hole
(C)
. (The leg support needs to be in the
same position on both sides.)
• Reinstall screws
(A)
and tighten.
Horizontal adjustment of the leg support (ang-
le adjustment of the footplate holder):
• (2)
loosen screws
(A)
on both sides,
• Place the footplate holder
(B)
on both
sides in the same desired position,
• Turn screws
(A)
tight again,
• if necessary, readjust the angle of the
leg support (see next point).
Horizontal adjustment of the leg support (ang-
le adjustment of the foot plate)
• (1)
loosen all screws
(D)
on both sides,
• bring leg support
(B)
to the desired
angle,
• tighten all screws
(D)
again.
Horizontal adjustment of the distance of the
leg support
(1 + 3)
To change the distance
by 30 or 60 mm / 3 or 6 cm turn the clamping
parts
(E)
by 180 ° and / or with the front holes
(F)
of the leg support screw.
• For moving the clamping parts:
• Remove screws
(D)
on both sides,
• Turn clamping parts
(E)
horizontally by
180 ° and
• Reinstall screws
(D)
and tighten tightly.
To move the leg support:
• Remove screws
(D)
on both sides,
• Put leg support in the alternative holes
(F)
and
• Reinstall screws
(D)
and tighten tightly.
(3)
(E)
(D)
(F)
(1)
(B)
(A)
(D) (E)
(F)
(C)
(G)
(2)
(A)
(B)
