14 of 28
Service Record Mio Carbon (Design 2018)
2020-09-01
3.3.1 Adjust back height
3.3 Assembly group back
In order to ensure the greatest possible freedom of movement of the arms when driving the
wheelchair, with active drivers, the back height should usually reach to the lower edge of the
shoulder blades.
(A)
(2)
(A)
(1)
For our solid firm curved backs, the upper
edge of model 3 is pulled upwards by approx.
50 mm / 5 cm (with model 1 approx. 20 mm
/ 2 cm). For a longer support of the spine is
achieved. Due to the bevel of the back plate
to the outside, the shoulder blades can still be
moved freely.
To change the position of the firm curved back
plate:
• (1 + 2)
completely remove screws
(A)
on both sides,
•
put firm curved back plate in the desi
-
red position,
• Reinstall screw connections
(A)
and
tighten tightly.
3.3.2 Adjust back angle
The back can be adjusted by moving the back-
rest at an angle of 0 °, + 5 °, + 10 °, -5 ° and
-10 °. Please note that the center of gravity of
the wheelchair shifts when adjusting the back-
rest.
• (3)
Loosen screw connections
(A)
on
both sides,
•
bring the firm curved back to the desi
-
red angle,
• Tighten screw connections in the corre-
sponding holes again.,
(A)
(3)
Try new setting only with the help of a helper!