Service Record Mio Carbon (Design 2018)
21 of 28
2020-09-01
3.8.3 Horizontal setting
(1)
The horizontal setting occurs on the one
hand by displacing the locking joint. Remove
both screws
(A)
, place the locking joint in the
alternate holes
(B)
, replace and retighten the
screws.
horizontal setting
(2)
On the other hand, it can occur by displac-
ing the cushions. Remove the covers, remove
the screws
(A)
, displace the cushion and re-
tighten the screws
(A)
. After, replace the covers.
Horizontal extension
(3)
For the horizontal extension add an exten-
sion piece (spare part): Remove the screw
(A)
,
add the extension piece and screw it together
on both ends.
(2)
(A)
(A)
(B)
(1)
(3)
(A)
3.8.4 Fine adjustment of the truss pad holder
(4)
The fine adjustment of the room between
locking joint and truss pad holder occurs with
the adjustment screw
(A)
.
3.8.5 Adjusting to the user
(5)
If all positioning and extension works are
finished close the truss pads, adjust the joints
in the necessary position and tighten all joint
screws
(3A)
. The ball joint is then fixated by
tighten the four screws
(B)
.
(A)
(4)
(A)
(5)
3.8 Assembly group truss pads
