Sony ZRCT-100, Installation Manual

Page: 42 / 171

2-8 (E)
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
2-4. Installation
2-4-1. Preparation
1. Assemble all bases and install them. (Refer to Section 1-3-1.)
Fix the bases to the floor with the anchors.
2. Assemble all back frames. (Refer to Section 1-3-2.)
Fix the back frames to the floor, wall and ceiling with the anchors.
3. Set the number of display units and layout of the whole array in advance using the unit alignment
tool.
For details on the setting procedure, refer to the document supplied with the unit alignment tool.
2-4-2. Required Equipment/Tools
For details on each tool, refer to “1-3. Required Equipment/Tools”.
Prepare the general tools such as screwdriver and hexagon wrench.
Equipment/tools No. of pcs Uses Remarks
Base
_
Joint cam plate should be attached.
For the base, including the required
equipment/tools, refer to Section 1-3-1.
Back frame
_
Refer to Section 1-3-2.
Mounting parts
_
For connecting between display unit and back
frame Refer to Section 1-3-2.
Unit alignment tool
_
For obtaining these tools, contact your
local Sony Sales Office/Service Center.
.
Camera block 1 Measurement block
.
Monitor block 1 Indication block
.
Adaptor 2 The support parts of the camera block and
the monitor block
.
Digital level
1 For checking the inclination between display
unit and back frame
.
AC cable 1 For battery of the camera block
.
AC cable 1 For indication monitor
.
Eccentric pin (long)
(
*
)
4 For adjustment in the X direction or in the Y
direction
.
Eccentric pin (short)
(
*
)
4 For adjustment in the Z direction or in the X
direction
.
Shaft lock bar
(
*
)
1 For locking/unlocking a shaft
.
Hexagon wrench
4 For the eccentric pin driver
.
X positioning tool 2 For positioning X direction (It is used when
you install the first display unit in the system.)
Hexagon wrench bit
(subtense:4 mm)
_
For tightening the mounting screw of a joint
coma
Torque driver (3.0 N
.
m)
_
For tightening the mounting screw of a joint
coma
(
*
) If you break or lose a tool, you can purchase the tool only what you require.
Name Part No. No. of pcs
Eccentric pin (long) 4-733-542-01 1
Eccentric pin (short) 4-733-541-01 1
Shaft lock bar 4-733-543-01 1