Sony StorStation LIB-D81, Product Description Manual

Page: 148 / 154

148
Appendix
2C
Failed reselection. Reselection
retried but gave up.
— Yes
2F
REQ/ACK handshake timeout
or controller chip interruption
timeout at the SCSI interface.
— Yes
30 Reports a unit attention event. — Yes
31
An as yet unsupported LUN
specified at the SCSI
interface.
— Yes
32 Loader not yet ready. — Yes
33 Loader front door open. — Yes
34
Currently in reprogramming
mode.
— Yes
35 Currently in menu mode. — Yes
36
Reported an information
exception condition.
— Yes
41
Reception of drive data
timeout at the drive interface. [L ] and [4 1] appear
alternately on the message
display.
Yes
42
Received data of abnormal
length from drive at the drive
interface. [L ] and [4 2] appear
alternately on the message
display.
Yes
43
Drive detected as offline at the
drive interface. [L ] and [4 3] appear
alternately on the message
display.
Yes
70
Detected calibration error
(lower sensor readings
abnormal). [L ] and [7 0] appear
alternately on the message
display.
Yes
71
Detected calibration error
(notch readings abnormal). [L ] and [7 1] appear
alternately on the message
display.
Yes
72
Detected calibration error.
(Upon calibration of the lower
edge of the drive rim, it was
detected that it needed to be
calibrated above the upper
limit.) [L ] and [7 2] appear
alternately on the message
display.
Yes
78
Because cartridge pickup
failed, when performing
recovery it is impossible to do
so because there are no
available slots. [L ] and [7 8] appear
alternately on the message
display.
Yes
7A
The door lock sensor does not
close when attempting to lock
the front door. [L ] and [7 A] appear
alternately on the message
display.
Yes
7B
The door lock sensor does not
lock when attempting to lock
the front door. [L ] and [7 B] appear
alternately on the message
display.
Yes
7C
The door lock sensor does not
unlock when attempting to
open the front door. [L ] and [7 C] appear
alternately on the message
display.
Yes
80
Detected a GAP when the
elevator is in movement. [L ] and [8 0] appear
alternately on the message
display.
Yes
81
Cannot detect the normal
number of notches when the
elevator is in movement. [L ] and [8 1] appear
alternately on the message
display.
Yes
Error code Description Display Logged