13
Getting Started
Getting Started
Step 6
Tuning your TV to the unit’s VCR
If you connected the unit to your TV using a EURO-AV cable, skip this step.
ON/STANDBY
P/–
RF CHANNEL
ON/STANDBY
1
Press ON/STANDBY to turn on the unit.
2
Press RF CHANNEL on the unit.
The factory-preset RF channel appears in the display
window.
The unit’s VCR signal is output through this channel to the
TV.
3
Turn on your TV and select a programme position
for the unit’s VCR picture.
4
Tune the TV’s programme position to the RF
channel shown in the display window so the
picture on the right appears on the TV screen.
Refer to your TV manual for tuning instructions.
If the picture does not appear clearly, see “To obtain a clear
picture from the unit’s VCR” below.
5
Press RF CHANNEL.
You have now tuned your TV to the unit’s VCR. Whenever
you want to play a video tape, set the TV to this programme
position. This programme position will now be referred to
as the VCR’s programme position.
RF
CHANNEL
RF
CHANNEL
SONY VIDEO CASSETTE
RECORDER
To check that the TV tuning is correct
Set the TV to the VCR’s programme position and press P/– on the unit. If the
TV screen changes to a different programme each time you press P/–, the TV
tuning is correct.
To obtain a clear picture from the unit’s VCR
If the picture does not appear clearly in step 4 above, press P/– in step 4, to
select another RF channel. Then tune the TV’s programme position to the new RF channel
until a clear picture appears.
RF
