Assigning Functions to the Lens Dials
149
Ch
apt
er 6 Men
u
and
Det
a
iled Set
tings
You can assign functions to each of the three dials
(outer, mid, inner) on the lens unit. Note that the
same function cannot be assigned to more than
one dial. The functions are assigned to the dials
using OPERATION >Lens Dial >Inner, Mid, or
Outer in the setup menu.
You can also change the direction of rotation of
the dial for each function.
You can assign the following functions to the lens
dials.
• Zoom
• Focus
• Convergence
• Iris
Setting the Direction of Rotation of the
Dials
You can change the direction of rotation of the
dial for each function assigned. The factory
default settings for the direction of rotation of the
dials are shown in the following table. You
change the operation of the dial by assigning
functions to the clockwise direction using the
Focus Clockwise, Zoom Clockwise, Conv.
Clockwise, and Iris Clockwise commands from
OPERATION >Dial Operation in the setup menu.
Note
The inner dial provides coarse adjustment for small
movements of the dial. Consequently, fine adjustment
may be difficult to achieve, depending on the assigned
function.
Assigning Functions to
the Lens Dials
Functions that can be Assigned to
the Lens Dials
Function
Clockwise
Counterclockwise
Focus
Near (Shifts
focus closer)
Far (Shifts focus
further away)
Zoom
Tele (Telephoto
zoom-in)
Wide (Wide angle
zoom-out)
Convergence Near (Shifts
convergence
closer)
Far (Shifts
convergence
further away)
Iris
Open (Opens
the iris
aperture)
Close (Closes the
iris aperture)
Summary of Contents for PMW-TD300
Page 185: ......
