Sony NSS-S2, Installation Manual

Page: 14 / 40

1-6 (E)
NSS-S2
1-6. Rack Mounting
c
.
Install in a stable space.
If the rack mount is installed on an incline or unstable
stand, the equipment may fall and cause injury.
. Use the specified rack mount rail.
If not, it may cause injury by falling off the unit because
strength of rail is not enough.
. Handling the unit by holding the designated positions.
When handling the unit, be sure to hold the following
positions.
Otherwise, the unit may break and fall, causing injury.
. Rack angle
. Bottom case
Especially, do not hold the front panel or the handle of
the power supply unit.
The unit can be mounted in an EIA standard 19-inch rack.
When installing the equipment in the rack, be sure to use
the specified rack mount rail and follow the procedure
described below. If the equipment is not installed correctly,
it may fall or the rack may fall.
Specified rack mount rail: RMM-10 (option)
n
Mount in the rack after removing the HDD from the unit.
Componets of RMM-10
. Rack brackets : 2 pcs
.
Rack mounting adaptor (right) : 1 pc
[Including two screws (B4
x
6: 7-682-560-09)]
. Rack mounting adaptor (left) : 1 pc
[Including two screws (B4 x 6: 7-682-560-09)]
.
Rack bracket fixing screws : 6 pcs
(B4
x
6: 7-682-560-09)
. Adaptor fixing screws (B4 x 10: 7-682-562-09) : 6 pcs
Required other parts
To mount the unit in the rack, the following parts
are required. (supplied with the NSS-S2)
. Screw (RK5 x 16: 7-682-378-04) : 4 pcs
.
Ornamental washers (2-297-913-01) : 4 pcs
n
Standard tightening torque value
Screw size Standard tightening torque value
M4.0 120 x 10 _ 2 N . m (12.2 kgf . cm)
B4 x 6
Foot holder
assembly
B4 x 6
B4 x 6
Rack bracket
Rack bracket
Rack mounting procedure
1. If there is any equipment with an HDD installed in the
rack and the main power on, turn off the main power.
2. Remove the four screws from the side of the unit, lift
up the unit, and remove the four foot-holder assem-
blies.
3. Attach the rack brackets on the side panels of the unit
with the specified six screws.
n
Be sure to use B4
x
6 as a screw.