32
GB
Editing a Recor
ded MD
Erasing the Entire Disc
(All Erase)
AMS
EDIT/NO
You can create names for your recorded MDs and as well
as the individual tracks. Names can consist of uppercase
and lowercase letters, numbers and symbols and each disc
can store about 1,700 characters.
You can enter names during playback, pause, recording,
or stop mode.
When naming a track during recording, be sure to finish
before the track ends. If the track ends before you finish
the naming procedure, the characters you entered will be
discarded and the track will remain unnamed.
When naming a track during playback, the track will
repeat until you finish entering the name.
1
Press EDIT/NO to display the Edit Menu.
2
Turn AMS to display “Name ?”, then press AMS.
This step is not necessary during recording.
3
Turn AMS to display “Nm In ?”, then press AMS.
4
Turn AMS to specify whether you wish to label the
disc or track.
During recording, skip to step 6 (only the track can be
named).
• To label the disc, turn AMS to display “Disc”
• To label the track, turn AMS so that the track
number blinks in the display.
5
Press AMS.
“New Name In” appears in the display and the cursor
starts blinking.
AMS
0/)
EDIT/NO
STOP
ENTER/YES
DISPLAY
Scrub dial
BANK 1
REHEARSAL
TRACK
20
40
-dB
L
R
TR
M
S
F
This function erases all of the information on the MD (all
recorded tracks, track names, and the disc name) in a
single operation.
1
During stop, play, or pause mode, press EDIT/NO to
display the Edit Menu.
2
Turn AMS to display “All Erase ?”, then press AMS.
“All Erase??” appears in the display.
3
Press AMS again to erase the MD.
“Complete!!” appears for a few seconds and the disc
name, all tracks, and all track names are erased.
To cancel without erasing the MD
Press EDIT/NO or STOP to exit the “All Erase ?” or “All
Erase??” display.
z
You can undo the erase
Use the undo function immediately after erasing the MD (see
page 35).
Naming Discs and Tracks
(Name)
