11
English
!
!
!
!
!
Cautions on Operation
1)
When a malfunction occurs, characters as shown in “9. Alarm Display” on page 73 are
displayed in place of numerals.When the alarm display appears, press the
RESET
key for the
relevant axis and repeat the operation.
2)
If two or more operation keys are pressed simultaneously, a malfunction may be caused.
3)
Make sure that the least significant digit of an entered value agrees with the selected resolution.
5. Operation
5-1. Initial Settings
Before staring the operation, make the following initial settings:
5-1-1. Setting the resolution and polarity
5-1-2. Setting resolution
5-1-3. Setting linear campensation
5-1-4. Setting the scaling
5-1-5. Setting offset value
∆
Y
5-1-7. Setting of touch sensor radius
5-1-8. RS232C setting
5-1-9. Setting inch/mm switching
•
Skip unnecessary initial settings by pressing an Axis selector key, and proceed to the next setting.
•
After all the initial settings are completed, press the
RESET
key. The value that was displayed before
the power was turned off is displayed, and the unit is switched to the measurement mode.
•
By pressing the
RESET
key at any time during initial setting, the value that was displayed before
the power was turned off is displayed, and the unit is switched to the measurement mode.
•
The initial settings, once made, are stored even if the power is turned off. Therefore the initial
settings are necessary only when the system is newly installed or when any setting revision is
required.
To set the initial setting mode
The resolution set for each axis will be displayed.
Hold down the X-axis
RESET
key and turn the power switch ON.
RESET
X
OFF
ON
1
2
Hold down
Power switch
Unless otherwise specified, the following descriptions apply to all axes. Therefore, only the
settings for the first axis are described.
Set the second and third axes in the same manner.
Note
When the type of scale axis changes, this mode is forcibly selected without pressing an axis
selector key.
