3-4
HDW-250
3-1. Setup Menu
EDIT
Display on LCD
Setup item
Setup value
Description
REC MODE
REC MODE
CRUSH
Sets the type of record mode.
ASSEMBLE
CRUSH :
The unit stops at the record end point.
AUTO ASSEMBLE
It re-starts next recording from the point.
Continuity of the video signal is not
maintained.
ASSEMBLE :
The unit stops after rewinding a tape for
about three seconds from the record
end point. It re-starts the next recording
from the point. Continuity of the video
signal is maintained.
AUTO ASSEMBLE : The unit stops after rewinding a tape
for about three seconds from the record
end point. It re-starts the next recording
from the point. Continuity of the video
signal is maintained. The next recording
starts automatically from the original
3-second-rewound point even though a
tape is moved after the previous recording
has ended as the tape is rewound as required.
PREROLL
PREROLL TIME
0 sec
Sets the pre-roll time from an external editing equipment that is
:
connected to the REMOTE connector. A pre-roll time in the
5 sec
range of 0 to 30 seconds in units of 1 second can be set. A
:
pre-roll time of 3 seconds or longer is used in general, but
30 sec
a pre-roll time of 5 seconds or more is recommended for editing
using an external editing equipment.
The items that are surrounded by square (
[|]
) in the Setup value column, show the default setting when shipped from the factory.
TIME CODE
Display on LCD
Setup item
Setup value
Description
REC RUN
REC RUN
INT
Sets the type of time code signal that recorded on tape when the
TAPE
F-RUN/R-RUN switch is set in “R-RUN”.
INT :
The time code signal that is generated by the internal
time code generator is recorded.
TAPE : The time code signal that is played back from a tape is
recorded.
EXT TC IN
EXTERNAL TC IN
TC IN
Selects the source of time code when the internal time code
SDI
generator of the unit is locked to an external time code.
TC IN : The internal time code generator of the unit is locked to
the input signal connected to the TC IN connector.
SDI :
The internal time code generator of the unit is locked to
the input signal connected to the SDI IN connector.
PHASE CRC
PHASE
OFF
Selects whether or not to control the phase compensation of the
CORRECTION
ON
LTC data that is generated by the time code generator.
OFF : Disables the phase compensation control.
ON : Enables the phase compensation control.
TCG CF FLG
TCG CF FLAG
OFF
Selects to set (turns on) the color frame flag or not to set (turns
ON
off) the color frame flag in the un-used bit of the time code data.
OFF : Turns off the color frame flag.
ON : Turns on the color frame flag.
TC OUT
TC OUT
GEN
Selects the signal that is output to the TC OUT connector.
AUTO
GEN : The time code signal that is generated by the internal
time code generator, is output.
AUTO : The time code signal that is generated by the internal
time code generator, is output during the record mode
(including E-E mode). The LTC data that has already
been recorded on tape, is output during the playback mode.
The items that are surrounded by square (
[|]
) in the Setup value column, show the default setting when shipped from the factory.
