67
4-28. CN-4065 Board
Preparation
1. Remove the outside assembly. (Refer to "4-4. Outside Assembly")
2. Remove the inside assembly. (Refer to "4-5. Inside Assembly")
3. Remove the rear panel assembly. (Refer to "4-18. Rear Panel Assembly")
4. Remove the rear harness protection sheet. (Refer to steps 1 and 2 in "4-19. DC Fan")
Procedure
1. Remove the two screws (PSW2 x 5) and two screws (P2.6 x 5), and then remove the CN-4065 board.
2. Disconnect the harness from the connector (CN001) on the CN-4065 board.
3. Install the removed parts by reversing the steps of removal.
PSW
2 x 5
P2.6 x 5
CN-4065 board
Harness
Rear panel assembly
CN001
This figure shows HDC-P50.
