Sony DXC-S500, Service Manual

Page: 25 / 148

2-1
DXC-S500 (E)
Section 2
Adjustment of After Replacement Board
n
This section describes the adjustment and confirmation
items required during board replacement. For the
updating, refer to “Section 3 Updating the CPU Program”.
For each electrical adjustment, refer to “Section 5
Electrical Alignment”.
2-1. CCD (Camera Front Assembly)
Perform the adjustment and confirmation below when
CCD is replaced.
.
White balance adjustment (Refer to Section 5-3-2.)
.
Standard sensitivity adjustment (Refer to Section 5-3-3.)
.
SHP phase adjustment (Refer to Section 5-3-4.)
.
Reading the CCD defect data (Refer to Section 5-3-5.)
.
Confirmation of white balance color lead-in operation
(Refer to Section 5-3-6.)
.
Confirmation of CCD cooling operation (Refer to
Section 5-3-7.)
2-2. PA-267 Board
Perform the adjustment below when the PA-267 board is
replaced.
.
White balance adjustment (Refer to Section 5-3-2.)
.
Standard sensitivity adjustment (Refer to Section 5-3-3.)
.
SHP phase adjustment (Refer to Section 5-3-4.)
.
Reading the CCD defect data (Refer to Section 5-3-5.)
.
Confirmation of white balance color lead-in operation
(Refer to Section 5-3-6.)
.
Confirmation of CCD cooling operation (Refer to
Section 5-3-7.)
2-3. CA-46 Board
Perform the adjustment below when the CA-46 board is
replaced.
.
White balance adjustment (Refer to Section 5-3-2.)
.
Standard sensitivity adjustment (Refer to Section 5-3-3.)
.
SHP phase adjustment (Refer to Section 5-3-4.)
.
Reading the CCD defect data (Refer to Section 5-3-5.)
.
Confirmation of white balance color lead-in operation
(Refer to Section 5-3-6.)
.
Confirmation of CCD cooling operation (Refer to
Section 5-3-7.)
2-4. SY-301 Board
.
Updating of main microcomputer (ARMCPU) software
(Refer to Section 3.)
.
Writing of initial data in IC523 (Refer to Section 2-4-1.)
.
CCU external video signal adjustment (Refer to Section
5-4-3.)
n
Adjust according to the NTSC/PAL mode when
performing the CCU external video signal adjustment.