13
Chapter 1 Introduction
Rear
A
Power Switch
Press this switch to turn the library on and off.
B
AC IN Connector
Connect the power cable.
C
Transport Screws for Drives (M3)
Place for attaching the transport screws for Drives after removing them during
installation.
D
LAN Connector
Connect a 10 Base-T/100 Base-TX network cable here.
E
Access Cover for Service Use
Remove the cover when adding or replacing drives. Do not open this cover. For
service use only. Contact your dealer for information about how to add or
replace drives.
F
SCSI Connector 1 (right side), SCSI Connector 2 (left side)
Connect the SCSI cable to this connector. For details about connection, see
“Connecting the SCSI Bus Cable” on page 20.
G
RS-232C Connector
For service use only. You do not normally need to use this connector.
H
Cooling Fan, Ventilation Hole
Be careful not to block the ventilation holes. If you do, the drive in the unit may
overheat, resulting in damage.
I
Door Lock Key
Place for attaching the door lock key for front door.
J
Transport Screw 1 (M4, upper), Transport Screw 2 (M4, center),
Transport Screw 3 (M3 with nut, lower)
Place for attaching the transport screws after removing them during installation.
1 2
4
3
5
6
7
8
9
0