Sontay SonNet Trend, Technical Manual

Page: 172 / 220

SIP SonNet-Trend - Interface Range
Contents
1 INTRODUCTION ...................................................................................................................................... 1
1.1 THE UNIT 3
1.1.1 Front Panel Annunciation ............................................................................................................... 3
1.1.2 Button and Switches ....................................................................................................................... 4
1.2 SYSTEM OVERVIEW .............................................................................................................................. 5
1.2.1 SonNet Network ............................................................................................................................. 6
1.2.2 Trend Network ................................................................................................................................ 6
2 HARDWARE GUIDE ................................................................................................................................ 7
47 Issue 1, Jun. 2014
Enter the ‘
Alarm Address
’ number. This identifies the device on the Ethernet network
used to display alarms generated by the third party devices on the network. Enter the
‘
On Remote LAN
’ number. This identifies the LAN that includes the device on the
Ethernet network used to display asserted alarms.
To use Trend IP alarm
Enable IP alarms (Internet Protocol), i.e.
 ‘
Use IP alarms
’. This allows the
transmission of IP alarm signals, but not Trend alarms, to the BeMS. Enter the
‘
IP
address
’. This identifies the device on the BeMS that will receive alarms messages.
Enter the ‘
Port
’ number. This identifies the internal port used to receive IP alarm
messages.
Note The IP address must be configured according to local company network policy.
47.
Press
‘
Save
’ to confirm the Trend ‘
Address
’ module changes. (see
The Configuration
Pages
).