59
2-5. Terminal Assembly
Preparation
1. Remove the bottom harness guard. (Refer to “2-2. Bottom Harness Guard”.)
2. Remove the outside panel assembly. (Refer to “2-3. Outside Panel Assembly”.)
Procedure
1. Remove the two precision screws, and then remove the SDI harness shield.
2. Disconnect the fine-wire coaxial cable from the connector (CN6001) on the SDI-127 board.
3. Disconnect the fine-wire coaxial cable from the connector (CN5001) on the TC-118 board.
Note
At the time of the installation, ensure that the portion A of the SDI harness shield comes in contact with the contact connector on
the SDI-127 board.
Precision screws
(P2 x 4)
CN6001
CN5001
SDI-127 board
TC-118 board
SDI harness shield
A
Contact connector
Fine-wire coaxial cable
Fine-wire coaxial cable
