47
2-3-5. VIF-78 Board
Preparation
1. Remove the bottom harness guard. (Refer to “2-2. Bottom Harness Guard”.)
2. Remove the outside panel assembly. (Refer to “2-3. Outside Panel Assembly”.)
3. Remove the XLR assembly. (Refer to “2-3-2. AXM-62 Board”.)
4. Remove the JK-108 board. (Refer to “2-3-4. JK-108 Board”.)
Procedure
1. Remove the two precision screws, and then remove the VF connector plate.
2. Release the hole and the notch of the VIF-78 board from the two bosses.
3. Remove the VIF-78 board in the direction of the arrow.
4. Disconnect the fine-wire coaxial cable from the connector (CN100) on the VIF-78 board.
5. Detach the ESD gasket.
6. Install the removed parts by reversing the steps of removal.
Hole
Notch
Viewfinder connector
Hole
CN100
VIF-78 board
Fine-wire coaxial cable
Bosses
Attaching position of ESD gasket
ESD gasket
ESD gasket
VF connector plate
Precision screws
(P2 x 4)
