26
Method of the ID writing:
•
When ID is readable
When the unit before repair can be turned on and ID adjustment values can be read using the Adjust Manual, perform the
following work.
Work:
1. Execute [Read and Save] of “RESTORE DATA” in the DATA tab.
2. After replacement with the repair VC board, execute [LOAD and WRITE] of “PRODUCT ID & USB SERIAL No. INPUT”
in the ADJUST tab of the Adjust Manual to write extracted data to the unit.
•
When ID is unreadable
When ID adjustment values cannot be read, perform the following work.
Work:
After replacement with the repair DPR-394 board, start the Adjust Manual from the Adjust Station and execute “PRODUCT ID
& USB SERIAL No. INPUT” to enter ID.
Update of MAC Address
When a board that contains Wi-Fi has been replaced or when replacing a board that contains the main IC (CPU) has been replaced,
the MAC address must be reloaded.
Procedure of the MAC address update:
Note
Perform the below operations after all work has been done.
1. Start the Adjust Manual in the Adjust Station and execute “Wireless LAN Setting (MAC Address)” on the ADJUST tab.
2. Perform “NETWORK RESET” on the NETWORKSET menu of the unit.
Applicable parts:
•
DPR-394 BOARD
•
CT-289 BOARD
Note
After the replacement and repair, as the board has a new MAC address, ask the customer to configure the devices connected to the
unit again.
Accordingly, download the Flyer of WLAN Reset (Flyer of WLAN Reset_9834752[][].pdf) and print out it, and attach it to the unit
when returning the set to customer.
1-7-3. Notes for Replacing the LCD Display Device
Adjustment values for each LCD display element are written on the PD-129 board of this unit.
Therefore, when the LCD or the PD-129 board is replaced, start the Adjust Manual from the Adjust Station. Then adjust the LCD
according to the Adjust Manual and write adjustment values.
1-7-4. Notes for Replacing the Front Unit Including CMOS Image Sensor
Load the data from the supplied CD ROM to the PC. Write the loaded data to the unit using “Imager DRA Data Write” in the
ADJUST tab of the Adjust Manual. After all adjustment items have been completed, execute “Phase Difference AF Check” in the
SERVICE tab of the Adjust Manual.
1-7-5. Firmware Update
After replacing the following boards, update the firmware.
•
DPR-394 board
•
DIF-287 board
•
VIO-38 board
•
DD-55 board
Tip
The firmware of these boards are updated at once by the update process.
