5
use the screws, the plane and spring washers (2, 3, 4) also. Make sure that it is firmly in its place, and
that the hook (3) can support the weight of the moving fan.
C. Insert the hanging tube (2) to the cover (1), pass the wires through the hanging tube. Insert the end
of the hanging tube (4) to the shaft of the motor unit (7). Fix it by passing the pin (5) through the tube
and at the end of the shaft, then plug the cotter (3) to the fixing pin. Bend the stems of the cotter.
Tighten the security screw (6) also.
D. Temporarily hang the product on the hook of the ceiling plate (1). Use a hole of the cover to this.
Connect the lamp electrically (4. figure). Ask for the help of a specialist!
Marking of the terminal block
Power cord
The lamp switch wire (black or brown) of the wall switch
(230 V~ / 50 Hz).
The fan switch wire (black or brown) of the wall switch
(230 V~ / 50 Hz).
N
Neutral wire of 230 V~ / 50 Hz mains network (blue wire).
Grounding wire of 230 V~ / 50 Hz mains network
(green/yellow wire).
E. Hook the fan off from the hook. Insert the cover to the ceiling plate’s two screws, rotate it into its place,
and then fix it by tightening all the 4 screws.
Rotate the hanging tube, until the top plastic shape’s (1) rib (3) does not fit into the groove of the
cover(2).
F. Screw the blades to the metal blade-holders.
G. Fix the metal blade-holders to the motor, with screws and spring washers.
H. Connect the two cord switches.
I. Connect the electrical connector of the luminaire (4) to the control unit (1). Screw the luminaire to the
control unit with 3 screws (3). Secure the lampshades (2) with the screws. Do not tighten over. Insert
max. 60 W light sources to the E27 sockets.
Kapcsolja fel a kismegszakítót.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble of modify the unit or its accessories. In case any part is damaged,
immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the
manufacturer, its service facility or similarly qualified personnel.
CLEANING, REPLACEMENT OF THE LIGHT SOURCE
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending
on the manner of use and degree of contamination.
1. Power off the device by switching off the circuit breaker of its circuit before cleaning and replacing the
light source.
2. Use a slightly moistened cloth to clean the unit’s exterior. Do not use any aggressive cleaners. Avoid
getting water inside of and on the electric components of the appliance.
3. If necessary, replace the cooled light source.
4. Install the fan again.
