ID
Option
Description
1
hard reset
A reset deletes all acquired and stored sensor data.
2
soft reset
(default)
All acquired and stored sensor data are kept for measurements and cal-
culations.
NOTE
During the installation a hard reset is recommended. After finishing the
installation a soft reset should be selected. This shortens start-up time.
D-H-J
Sleep mode
generic-sleep-mode
Defines the behavior of the USH-9 between two measurements, provided the measurement interval
is longer than the time of the measurement itself. The following options are available:
ID
Option
Description
1
MODBUS,
fast
For MODBUS applications. The USH-9 stays in normal mode. This option per-
mits high data transmission rates, but increases power consumption.
2
MODBUS,
slow
For MODBUS applications. The USH-9 goes into idle mode and can be woken
up by a command via the RS-485 interface with a low baud rate. This option
reduces power consumption at lower data transmission rates.
3
Standard
(default)
The USH-9 goes into sleep mode and can be woken up by a command via the
RS-485 interface only with a time delay. Option with the lowest power con-
sumption.
D-H-K
Sommer ID
generic-sommer-id
The Sommer ID is used to define stations within the Commander software. The ID is preset in the
device and corresponds to its serial number.SOMMER suggests not to change the ID, except if a USH-
9 device is replaced. In such a case it can be practical to change the ID of the new device to the ID of
the replaced device to guarantee data consistency.
D-I
RS-485 Protocol
D-I-A
1
4
P
ar
am
et
er
d
ef
in
it
io
n
s
114
Manual
