SOMMER USH-9, Manual

Page: 109 / 132

If a limit defined in Status limits is reached, the status of IOUT2 is set to high and 20 mA is applied to
the output. This status is maintained until the specified hold time elapses. Setting this parameter sup-
presses a flickering signal if the monitored variable fluctuates around the limit value.
Value range Default Units
0…360 30 (default) min
D-F-I Simulate current output
generic-analog-out-simulate-current
With this function the analog outputs can be simulated. Upon submission of a current value between
4 and 20 mA the corresponding values of the selected variable are displayed. The selected current is
also applied to the analog outputs and can be read with a connected data logger or multimeter. By
pressing Return/Enter again the simulation stops.
NOTE
If Status is deactivated, no current output can be simulated.
If Status is set to just during TRIG , the trigger must be set prior to simulation.
Additionally, the trigger must be reset before each simulation.
D-G Status limits
D-G-A Level limit 109
D-G-B Snow settling, strength drop 110
D-G-C Snow settling, maximum level 110
D-G-D Snowfall, precipitation limit 110
D-G-E Snowfall, max. temperature 110
D-G-A Level limit
ush-level-limit
The level above which the status is set to high. This limit is used to report significant levels or snow
depths.
Value range Default Units
0…99ˈ999ˈ999 0 mm
1
4
P
ar
am
et
er
d
ef
in
it
io
n
s
Manual 109