Copyright © 2013 - 2014 Somfy SAS. All rights reserved.
Yslo Flex RTS 2P
23
18.2. Maintenance operation requiring the housing to be unclipped
18.2.1. Restoring the original configuration
Restoring the original configuration deletes the change in priority panel, all the control points as well
as the saved sensors and favourite position, and the buzzer is deactivated.
• Press and hold the button no. 4 on the Yslo Flex RTS 2P board:
- The priority panel makes a first back-and-forth
movement with a beep and then a second back-and-
forth movement with 2 beeps a few moments later.
The original configuration is restored at the end of the
second back-and-forth movement.
18.2.2. Replacing the battery
Refer to the Yslo Flex battery After-sales kit guide.
there is a risk of explosion if the battery is replaced with an incorrect battery type. Dispose of
used batteries in accordance with the instructions.
Please separate the storage cells and batteries from other types of waste and recycle them via
your local collection facility.
In the event of a power outage, you can use your swing shutter thanks to the integrated battery,
however, the buzzer keeps beeping throughout the movements.
The battery can operate for 20 movements maximum.
18.2.3. Replacing a lost or broken control point
• To replace a lost or broken control point, unclip the housing and repeat the commissioning procedure.
See Section "Commissioning"
19. Technical data
Yslo Flex RTS 2P
Size
W = 95 mm - H = 70 mm
Reveal width (Wr)
880 mm ≤ Wr ≤ 1,520
mm
Radio frequency
433.42 MHz
Power supply
230 V ~ 50 Hz
Operating temperature
- 20 to + 60°C
Safety level
Category II
Protection rating
IP 24
Maximum rotation speed in shaft output
1.5 rpm
Maximum number of associated RTS control points
12
Maximum number of associated RTS sensors
3
BIP
BIP... BIP
≈ 7 s
BIP
BIP... BIP
