Copyright © 2013 - 2014 Somfy SAS. All rights reserved.
Yslo Flex RTS 2P
14
9) Remove the mechanical module
g
and drill holes.
10) Position the mechanical module
g
again on the bracket,
aligned with the mounting holes. Fix and tighten the two
modules with suitable screws. (make sure they are as
parallel as possible to the pencil line).
The anchors used must be able to withstand forces of
at least 40 kg. The mechanical module must be fixed
in at least two points.
Somfy recommends that you use screws with a
diameter of at least six millimetres.
The choice of the fixing method depends on the
nature of the support, and therefore, it will be under
your sole responsibility.
6. Wiring
The power cable must be protected from the movement of the swing shutter.
To avoid damaging the antenna and reducing the radio range:
- Do not modify the cable routing within the product.
- Do not cut the cable inside the product.
1) Switch the power supply off.
2) Connect the red wire of the battery to
the (+) terminal of the battery
on the control board
3) Connect the black wire of the PCB to
the (-) terminal of the battery
: Yslo Flex RTS 2P will begin
to beep.
4) Connect the motor cable
e
to the connector of the electromechanical module
d
.
5) Connect the motor cable
e
to the connector of the mechanical module
g
.
Use ties
y
to maintain the cables in place.
1
OFF
2
3
4
5
Batterie
g
d
e
y
g
